BTE Meat Grill
New BTE Gas Fired Oven |
|
||
Manufacturer: |
BTE |
||
Item: |
Gas Fired Grill |
Inventory No.: |
NA |
Condition: |
New |
Model: |
BTE-CG-24 |
Quantity: |
1 |
Serial No.: |
TBD |
Voltage: |
230 or 460v/3ph/60hz |
Grill Type: |
S.S. Angle |
Dimensions: |
27’ Long x 42.5” Wide Chicken Grill |
TWO CONVEYOR TYPE CHICKEN GRILL
EQUIPMENT DETAILS:
Major components & a description of the Oven is listed below:
- 2-Zone Grill length 27’L x 42.5”W
- 24 Fixed Telescoping Legs for Leveling the grill to the Floor
- Grill is 304 Stainless Steel
- Insulation is High Temperature Rockwool Type (300mm sides, 250mm top, 130mm
bottom)
- Up to 950 Grill Slates constructed of 304 S/S
. Chain Guide rail will be bolted on with 1-1/4” shafts studs bolted to the 10” S/S C-Channel
- Two (2) Packaged Burner Assemblies (Burners Top & Sides will be enclosed)
- Two (2) Complete Gas Trane Assemblies
- Exterior Skin is 304 Stainless Steel
- Bottom Floor has 6 drain holes
- 12 Insulated side removable panels for cleaning (*3 each side included)
. All top 16 gauge SS Panels are removable
- Includes UL Listed Components Control Panel with Temperature Controls and High
Temperature Limits
. Refer to new print with updated changes from previous rill manufactured by BTE (located in
Phoenix)
EQUIPMENT SPECIFICATIONS
- Conveyor Speed: 10-50 FPM
- Range Oven Air Temp.: 100-800 Degrees Fahrenheit
- Burner BTU’s: 1.2 Million BTU’s each Burner
- Electrical Power Required: UL
The Grill will be fully assembled fully assembled in one module that will fit trucking. Field wiring, Gas Drops and Exhaust will be installed onsite and part of installation. Exhaust Pipe & Field wiring materials are not included and will be quoted separate.
BURNERS:
Each Oven Zone is furnished with a packaged Maxon 415 burner assembly (*changed from 412 see MISC). Each assembly includes all parts and safety devices necessary for control and safety supervision. The 40 to 1 firing turndown ratio provides wide process flexibility. Burner assemblies are pre-piped and pre-wired in easy to install modules. Each burner has a locally, mounted NEMA 4 junction box, combination blower air-inlet filter, air and gas mixing system, pilot flame system, spark ignition, flame detector and discharge sleeve. Each burner chamber has safety blow off panels. The gas train & safeties meet or exceed NFPA 86. Each Blower will have a Noise Shield.
CONTROLS:
- Temperature Controls
All zones of the oven are individually controlled for a temperature range of 100°F to 650 °F. Each is digitally operated, which receives a signal from a thermocouple mounted in the supply air stream. This digitally controls the fuel supply valve to maintain the design set point temperature.
- Control Panel
One Control Panel is provided for the system. The Panel is powder coated mild steel. The components are Allen Bradley or other main brand for UL. The unit is pre-wired and free standing, complete with burner ignition and flame safety monitoring systems with diagnostic lights. The Panel is completely factory wired internally and tested prior to shipment, minimizing technical problems in the field. OVEN PANEL WILL BE UL LISTED COMPONENTS.